Live Tailstock Drill Chuck Kit with Chuck Reversing Adapter for Woodtu

$ 87.50 · 4.6 (575) · In stock

Complete Live Tail stock Drill Chuck Kit is the perfect solution for aligning and supporting a turning for bottom finishing on a woodturning lathe.
Complete Live Tail stock Drill Chuck Kit is the perfect solution for aligning and supporting a turning for bottom finishing on a woodturning lathe. The video below demonstrates this kit being used with a vacuum chuck. This kit includes the following: Live (rotating) 1/2 keyed drill chuck with MT2 mount. Fits most wood lathe tail stocks. 1 - Chuck Reversing Adapter with either 1-8 or 1 1/4-8 threads. Choose size with radio buttons. 1 - 1/4 diameter x 4 length center point 1 - 3/8 diameter x 4 length center point 1 - 1/2 diameter x 4 length center point 1 - 3/4 diameter x 1½ length center point 6 - Non marking vinyl caps used over the flat end of the center points. Sizes 1/4, 3/8 and 1/2 The flat end of the center points covered with these caps are used to eliminate the center point mark in the bottom of a turning. 1 - Chuck key Allows precision centering and holding of your work at the tail stock end of your wood lathe. Very useful to support small diameter work where a live center is not practical. Ideal for holding the chuck reversing adapter, mandrels, dowels and tenons up to 1/2 dia. The shank is 2 Morse taper. The drill chuck has 1/2 capacity.