Input Shaper without effect?! - General Discussion - Klipper

Basic Information: Printer Model: Kingroon KP3S MCU / Printerboard: Kingroon KP3 V1.2 klippy.log klippy.log (20.1 KB) Describe your issue: Hi folks, although it says “Never change a running system” or something similar I changed the print head of this little fellow and swapped the RasPi 3 with an OrangePi Zero that was used on my CoreXY before. Before all this I think I found a good config in terms of input shaping. Due to changed mass of the print head I rerun resonance measurement

Am I suppose to uncomment input shaper or is it set after running

Klipper Pressure Advance Tuning - How to Guide