So I bought this kinetix plenum used and had to use stock hardware

planning 2 mount a pull-up bar (3 anchor bolts each side) on an uneven wall. plan is a chemical resin to anchor the bolts. bottom & middle bolts i believe will be

question) why do sockets have beveled edges : r/Tools

DAN A4 v4 is not compatible with 14mm fan under MB!! Riser cable has broken! : r/sffpc

Can you adjust exhaust tip height? I just installed the ISR performance straight pipe exhaust, but the left tips are resting almost half an inch lower than the right. : r/genesiscoupe

Just put on a set of alba racing a arms and trx540r shocks and now I have this. How to deal with this camber issue. Any idea how to fix this? 2012

Just put on a set of alba racing a arms and trx540r shocks and now I have this. How to deal with this camber issue. Any idea how to fix this? 2012

Any advice on how I can unscrew these seized+rusted bolts on my 2011 Toyota Avensis battery terminals? On day 3 and felt like I have tried 'everything'. : r/MechanicAdvice

Why does Shimano use the plastic preload cap : r/MTB

I want them flat. I know the pins are ductile so they don't bend. Must I soder? : r/arduino

Just put on a set of alba racing a arms and trx540r shocks and now I have this. How to deal with this camber issue. Any idea how to fix this? 2012

Axle too short?? Replaced old bottom bracket with new BBRS500. Old Shimano Tiagra cranks seem too short, a few mm threads on left crank arm still exposed, little safety clip won't close.

Just got my S1 and printed a test cube. Retraction 0.8 speed 30 with Enders pla that came with the machine. Any input into fixing this print appreciated : r/Ender3S1

Are this injectors threaded or press fitted? The fuel port doesn't allow it to turn but they won't budge when I pull so I don't know how to remove them, it's from a Chrysler Grand Voyager 2005 2.8 crd : r/MechanicAdvice

Cutting fork sizing questions with expansion plug : r/bikewrench